Lammily Wheelchair Instructions

Thank you for getting the Lammily Wheelchair! Let’s assemble it! If you have any questions regarding assembly, please email [email protected]. If you prefer to watch instructions on video, please check out this link.

1. Make sure you have all the parts.

2. Place side A as shown below. Because side B, in reverse position, looks very similar to side A, make sure you DO NOT place side B.

3. Connect bar to side A using the hole circled below. Make sure the connection locks in place.

4. Connect wide X to side A using the holes circled below. Make sure the connections lock in place.

5. Connect bar to side A using the hole circled below. Make sure the connection locks in place.

6. Connect short X to side A using the holes circled below. Make sure the connections lock in place.

7. Connect short X to side A using the holes circled below. Make sure the connections lock in place.

8. Connect bar to side A using the hole circled below. Make sure the connection locks in place.

9. Now line up side B on top of the connections you just made.

10. Press down so that side B is locked in place. Don’t worry about pressing too hard! The connections are very sturdy. It’s recommended that you start pressing on one side and then put pressure through the rest of the connections.

Now side A and side B are 100% connected, forming the base of the wheelchair.

11. Place wheel pin through one of the wheels.

12. Position through one of the two holes on the frame like so.

13. Lock it in place by pressing down with a wheel lock.

14. Repeat steps 11-13 on the other side so that your 2 large wheels are connected. Your wheelchair is starting to take shape!

15. Position a small wheel in between the two-part small wheel assembly and hold it in place with your fingers.

16. Place this in between one of the 2 knobs and fasten it in place with 2 fasteners.

17. Repeat on other side. Now your wheelchair has all 4 of its wheels!

18. Time for the seat cover! Line up the seat cover to wheelchair as shown below and fold velcro around the 3 bars.

It’s recommended that you fold the velcro around the bar shown in image below, and then proceed to the wrap the velcro around bar closest to axis and then bar closest to the edge of the seat. When wrapping around the bars, make sure you do not wrap around short X or wide X, just the bars.

19. Here’s how the seat cover should look like from the behind and from bottom of wheelchair.

20. Put screw through washer.

21. Use screwdriver to attach leg rest. Repeat on other side.

22. Attach the rim to wheel. Repeat on other side.

23. You did it!

Your wheelchair is ready for its big reveal! It fits Lammily, Barbie, Monster High, any fashion doll on the market. Use the adjustable leg rests to adjust the fit of the wheelchair.